Ritter EBT Manuel d'installation télécharger pdf (Page 13)

9

MOUNTING BREAD BIN LID

FASTENINGS

• Place the bread bin (1) into the (inserted)

drawer.

• Shorten the supporting pipe (3) to the

correct length (inner carcass width minus

8 mm).

• If necessary, route the supporting pipe

into the lid rack (6).

• Align the supporting pipe parallel to the

bread bin lid (2) at a distance of 16 mm

(Figure D).

• Place the bread bin lid onto the bread bin:

– The "ritter" emblem should be visible at

the front.

– The bread bin lid should contact the

front of the drawer

Figure D:

• Pull the drawer out far enough, so that

the supporting pipe makes contact with

the front edge of the carcass side.

• Mark the upper edge of the supporting

pipe on the left and right of the inside of

the carcass.

• Remove the bread bin lid and the bread

bin.

• Remove the drawer.

Figure E:

• Use the drill template and a centre punch

to mark the following on the right-hand of

the carcass interior:

– the holes for the right retaining

bracket (10)

– the holes for the lid carrier (11)

Figure F:

• Use the drill template and a centre punch

to mark the holes for the left retaining

bracket (10) on the left of the carcass

interior.

• Drill the marked holes (Ø4.5 mm x 10 mm).

INSTALLING VENTILATION BEZEL

• Drill the hole for the ventilation bezel (7)

(Ø44 mm):

– on the rear side of the carcass

– in the centre, level with the bread bin

• Insert the ventilation bezel.

FINALISATION

• Insert the retaining brackets (10) into the

bores and fasten them in place using the

fastening screws (13).

• Insert the bread bin lid (2) with the sup-

porting pipe (3) into the retaining brack-

ets.

• Mount the lid carrier (11) using the fasten-

ing screw (14).

• Insert the drawer.

• Place the bread bin into the drawer.

• Check the position of the lid carrier:

– The lid carrier ts ush to the front of

the bread bin

– The lid carrier must not contact the side

of the bread bin when the drawer is

pulled out

• If necessary, adjust the position of the lid

carrier (6).

• Tighten all screws.

English

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 29 30

Commentaires sur ces manuels

Pas de commentaire